This device is a Dash Programmer or ECU Flasher designed for Vehicles using the NEC MCU such as Citroen, Peugeot, Hyundai, Honda, Suzuki, Renault, Opel, Alfa, Chevrolet (please refer to the Applicable Models below) that allows you to modify/reprogram your car’s computer or correct the odometer reading.
BDM 100 is a universal reader/programmer(it does not require our RACE software necessarily) that allows the user to read and program files in the ECU supplied with MOTOROLA MPC5xx processor (essential).
KWP2000 Plus ECU Remap Flasher Tuning Tool can read and analyze current ECU software,upgrade the ECU software with a re-mapped file,and repair ECUS with software problems or corruption.
In circuit / on board EEPROM/FLASH programming
The XProg-m programmer is designed to replace the earlier version of XProg-M programmer.It is fully upward-compatible hardware with XProg-M programmer and have many additional features.
It is a USB chip tuning interface. This is good clone working with V13 version of software.This interface lets you to read and write memory of a car computer through the diagnostic connector.
VP-896 is a reliable, high speed, high performance and low cost advanced universal programmer. It is a perfect over-current protection circuit, short-circuit will not damage the chip programmer.
MPPS Chiptuning Flasher supports new EDC16, EDC17, MED9.x, Siemens PPD1/x, EDC15, ME7.x and many other. Professionaly made, no obsolete boxes of cables, all the electronics fits the OBD plug.
Latest version V54, for all cars, trucks, motorcycles, Marine, BDM MPCxx, BDM Boot Mode, checksum
BDM FRAME with Adapters Set made from hight quality Plexiglass ,can use on BDM100 programmer , CMD,ETC. )
This is an universal equipment especially designed for MCU and EPROMs programming.